Our control units in the emergency switchgear are produced according to customer requirements. We will send you a detailed offer.
Possible supply of control units
Emergency power generator: Typ WA 800 / 3 – 0–0 to VDE 0100 Teil 718,
Power: 500 KVA / 722 Ampere
Protection: IP 42
External dimensions: Ca. 1800 * 800 * 400 mm ( H x W x T ), with base 200 mm
Modes: Load test in isolated operation, automatic, load test parallel to the mains
Consisting of
– All sides solid stell cabinet RAL 7035
– 1 one circuit breaker, 800 A / 3-pole with power element
– 1 Voltmeter
– 1 Voltmeter change over switch
– 1 gauge heat selector switch
– 1 Frequency meter
– 3 Bimetal amperemeter
– 1 active power meter
– 1 hours counter
– 1 battery voltmeter
– 1 battery ampere meter
– 1 horn electric 105 dba
– 1 automatic control panel, 16 alarms to VDE 0100 Part 718
– 1 batters charger
– 1 controler for 2 louvers
– 1 controler for cooling water heater <3 KW
– 1 controler for fuel pump 4 KW
– 1 fuse out “Flexwell” with fault leackage
– 1 all water warning device with fault leackage
– 1 controler springler request with springler test and springer operating
– 1 alternator overload and short circuit relais
– 1 activation for external mains circuit breaker
– 1 set of potential free contacts to VDE 0108
– 3 potential free contacts for elevator evacuation
– 1 cntroller for peak lopping operation
– 1 device for synchronisation and frequency
– 1 controller for speed adjustmen with electric set point device
– 1 peak load controler
– 1 voltage alarm with under and over voltage relais under and over frequency
– 1 vector skip relais with test key
The standard series DIN VDE 0108 part 1 bis 8 was replaced on 1 October 2005 by DIN VDE 0100-718 in conjunction with DIN VDE 0100-560 and DIN EN 50172 (VDE 0108-100).